- All prices are plus VAT at 20% -

Crankcase

Type 4 case

Crankcases

New factory crankcases pre 1980 type, limited quantities available, a must for the serious engine builder £799.00
Used and checked crankcase - these are used cases that are chemical cleaned, hot washed + oil galley rear plugs removed, drilled and tapped to ensure correct internal cleaning of the oil galleys, main bearing journals align bored to 0.50mm. £499.00
New factory VW Type 25 80-83 crankcase. Limited quantities available. £799.00

NOTE when ordering a case further machine work can be carried out eg > 911 fan cut, sleeve and bush follower bores for light weight lifter use, bore to 103mm, clearence for stroker crankshaft. Please call to discuss.

 

Crankcase Hardware

Heavy duty ARP case through bolt kit, special hi-torque studs with 12 point nuts and hardend washers. POA
Heavy duty ARP style cylinder stud kit, same thread as the case so no need for inserts, supplied with special nuts and washer set. Torque to 32lbs. £255.00 per set
Camshaft sealing plug £4.00
8mm stainless steel case nuts with correct wavy washer for 1 engine case POA
Flywheel oil seal (German) £14.00
Fan pulley seal (German) £6.99
Oil relief piston £6.99
Oil relief spring £4.99
Oil relief screw plug £4.20
H/D oil relief piston+spring (fits on the cam bore galley) £8.99
H/D dual oil relief spring kit £9.50
Oil strainer gauze £8.99
Oil plate gasket and seal washer £2.50
Oil pick-up plate (inside the case, please state year of engine) £30.00
Oil baffle plate (original VW to stop oil surge) From £25.00
Oil baffle plate seals (4 needed) POA
Clutch bolt with wave washer 7mm/11mm head used on 215 flywheels £6.50 per set
Flywheel Oring seal £3.25
Flywheel felt seal £1.45
Flywheel bolt set genuine 914 Porsche longer than VW (used) £21.00 per set
Crank/flywheel spigot bearing oem vw part £7.00
7mm/11mm rocker shaft nuts and wavy washers £5.00 per engine set
Thermostat cable in stainless steel £5.90
Oil dipstick bellows (fits between the housing and the case) £3.99

 

Main Bearings

Genuine VW Germany factory set. std x std £109.00
std x std steel backed £69.00
std x 0.25 steel backed £69.00
std x 0.50 steel backed £69.00
std x 0.75 steel backed £79.00
0.50 x std ally backed £69.00
0.50 x 0.25 ally backed £69.00
0.50 x std steel backed OEM old style mahle £139.00
0.50 x 0.25 steel backed OEM old style mahle £139.00
0.50 x 0.50 steel backed old style OEM mahle £139.00
1.00 x std steel backed POA
1.00 x 0.25 steel backed POA

NOTE oversize main bearings are available with standard flange and 1mm

 

Bearing Ancillaries

Main bearing dowel locating pins £1.00 each
Main bearing dowel pin (Set) £5.00